Sherwood D-480 User Manual download pdf (Page 13)

󳀏

When this unit is connected to a Sherwood DIGI LINK Ⅲ CD player controlled remotely by the DIGI LINK

system, the CD Synchro record function can be operated.

󳀏

Before starting CD synchro recording, adjust the recording level and the balance.

RECORDING A CD AUTOMATICALLY

Repeat steps 1,2,3 and 4 of “RECORDING”

Procedure.

According to the tape length, edit the

tracks to be recorded on the CD player

referring to the operating instructions of

that.

Start CD syncro recording.

󳀏

The CD is selected automatically on the amplifier DIGI LINK Ⅲ receiver.

󳀏

If 8 seconds elapses after starting recording, the CD player starts play automatically.

NOTE

󳀏Only when the erase protection taps on the cassette tapes are in place, CD synchro record function will be

operated.

󳀏During CD synchro recording, if other program source on the receiver is selected, the unit stops CD

synchro recording and starts recording the selected program source.

DUBBING FROM DECK B to DECK A

Open the cassette door by pressing the

EJECT button and load a blank cassette

tape into DECK A and prerecorded

cassette tape into DECK B.

Select the reverse mode

ENGLISH

: Recording of a single side.

: Recording of both sides.

NORMHIGH

SYN MPX MIN SEC

RELAY

REC

dB -00 -20 -10 -6 -3 0 +3 +6

CD SYN REC

REVERSE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Sherwood D-480 User Manual Page 13