Sherwood R-872 Operations Instructions download pdf (Page 25)

Programming a macro function

• The macro function enables you to program a

series of button operations(up to 15) on this

remote control into a single button.

• You can store up to three separate macro

command sequences into "M1", "M2" and "M3"

buttons.

1. Perform the steps 3 and 4 in "Entering a setup

code" procedure on page 21 to select the macro

mode ("MACRO").

• Then "M1" is displayed on the LCD screen for

several seconds.

• During macro setting operation, pressing any of

the DEVICE buttons cannot exit from the macro

mode.

2. While "M1" is displayed, press the CURSOR

UP( )/DOWN( ) buttons to select the MACRO

button to be programmed into, then press the

ENTER button.

• Each time the CURSOR UP( )/DOWN( )

buttons are pressed, "M1", "M2" or "M3" is

selected.

• Then "SEL" is flickering.

• If "SEL" goes off, start again from the above

step 1.

25

3. While "SEL" is flickering, press the operation

buttons you want to program in order.

Example: When playing a DVD on the DVD player

connected to VIDEO 2 jacks of this

receiver.

. Press "AUDIO" button to control this receiver.

. Press "POWER ON" button to turn this

receiver on.

. Press "VIDEO 2(7)" button to select the

desired input source.

. Press "DVD" button to control the DVD player.

. Press "POWER ON" button to turn the DVD

player on.

. Press "PLAY ( )" button to start playback.

• Each time the operation buttons are pressed, the

programmed order is displayed.

4. Press any of the MACRO buttons (M1~M3) to

complete the programming.

• Then "OK" is displayed.

To erase a macro program

• When erasing a macro program, perform the

above steps 1, 2 and 4, but ignore the step 3.

To change a macro program

• When a new macro program is stored into a

MACRO button with performing the above steps

1 to 4, the previous macro program is erased

from the memory of the MACRO button.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 83 84

Comments to this Manuals

No comments