Sherwood R-872 Operations Instructions download pdf (Page 67)

SETTING THE CH LEVEL SETUP

Memory mode

Note :

• Depending on the speaker settings("NO", etc.),

some channels cannot be selected.

Adjusting the current channel level

• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s

memory("CALIBRATE"), not into preset memory("REFERENCE 1", "REFERENCE 2").

• After adjusting each channel level with test tone, adjust the channel levels either according to the program

sources or to suit your tastes.(For details, refer to "Adjusting each channel level with test tone" on page 37.)

1. Press the CURSOR UP( )/DOWN( ) buttons to select the desired channel.

When adjusting the LFE LEVEL

Press the CURSOR UP( )/DOWN(

button.

Press the CURSOR UP( )/DOWN(

2. Press the CURSOR LEFT( )/RIGHT(

source's LFE as desired.

) buttons to select the LFE LEVEL SETUP, then press the ENTER

) buttons to select the desired program source.

) buttons to adjust the level of the selected channel or program

• The LFE level can be adjusted within the range of -10

~ 0 dB and other channel levels within the range of -15

~ +15 dB

• In general, we recommend the LFE level to be

adjusted to 0 dB.(However, the recommended

LFE level for some early DTS software is -10 dB.) If

the recommended levels seem too high, lower setting

as necessary.

3. Repeat the above steps 1 and 2 to adjust each channel level.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 83 84

No comments

Sherwood R-872 Operations Instructions Page 67