Sherwood SR 7206 Specifications download pdf (Page 7)

www.sherwoodscuba.com

1. If the Second and First stages are still connected together, record the First Stage and Second Stage serial

numbers and an inventory of all attached accessories before beginning disassembly.

2. Perform an inspection of the regulator in accordance with the Annual Inspection Guidelines. This process will

provide an assessment of the regulator condition before the service is performed This information may be

valuable to understand any conditions that are not corrected by the standard service.

3. Retract the Hose Protector at the First Stage and disconnect the LP Hose from the First Stage using a 9/16" open

end wrench. Set aside the First Stage for service.

4. Retract the Second Stage Hose Protector (27) and use a 5/8" open end wrench to loosen the connection and

remove the LP Hose (1) from the Valve Body (9). Remove and discard O-ring (4) and set aside hose assembly

for cleaning and reassembly.

5. Remove the Front Cover Assembly by grasping the Cover Ring (23) and rotating it counterclockwise. Inspect

the ﬂexible Cover (24) for signs of tears, holes or other damage. Replace if damage is evident. If no damage is

found go to step 7.

SECTION

DISASSEMBLY PROCEDURE

NOTE – Generally it is unnecessary to disassemble the Front Cover Assembly when performing

standard service. Cleaning can be adequately accomplished by rinsing and scrubbing if necessary with

a soft brush. However if damage to the Cover is observed, and it must be disassembled to replace parts,

proceed as described below.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Sherwood SR 7206 Specifications Page 7