Sherwood RD-7503 Troubleshooting Guide download pdf (Page 20)

ENGLISH

Programming a macro function

• The macro function enables you to program a

series of button operations(up to 10) on this

remote control into a single button.

• You can store up to three separate macro

command sequences into "M1", "M2" and "M3"

buttons.

• If the macro mode is entered, the SET LED will

flicker once.

Example: When programming a series of button

operations into "M1" button.

1. Press and hold down both "ENTER" button and

one of three NUMERIC buttons ("1" ~ "3")

corresponding to "M1"~"M3" buttons for more

than 1 second.

Note :

You should press the corresponding DEVICE

buttons before pressing each operation button.

Example: When playing a DVD on the DVD

player connected to VIDEO 3 jacks of

this receiver.

. Press "AVR" button to control this receiver.

. Press "POWER ON" button to turn this

receiver on.

. Press "AVR" button to control this receiver.

. Press "VIDEO 3(8)" button to select the

desired input source.

. Press "DVD" button to control the DVD player.

. Press "POWER ON" button to turn the DVD

player on.

. Press "DVD" button to control the DVD player.

. Press "" button to start playback.

2. Press the operation buttons you want to

program in order.

3. Press "ENTER" button.

• If the programming is performed successfully, the

SET LED will flicker twice.

�To remove a macro program

• When removing a macro program, perform the

above steps 1 and 3, but ignore the step 2.

�To change a macro program

• When a new macro program is stored into a

MACRO button with performing the above steps

1 to 3, the previous macro program is cleared

from the memory of the MACRO button.

Operating a macro function

Notes:

• The codes programmed into a MACRO button will be

transmitted at an interval of 0.5 seconds. However,

some components may not be able to complete one

operation in 0.5 seconds and may miss the next code.

In this case, the macro function cannot control the

corresponding components correctly.

• Be sure to use the remote control within the remote

control operation range of the components.

• Depending on the operation status of the components,

etc., the macro function cannot control the

corresponding components correctly.

• Aim the remote control at the REMOTE SENSORs of

the components to be controlled and press the MACRO

button you want.

Example: When pressing "M1" button.

RD-7503(A) 2008.11.4 1:45 PM 페이지 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 68 69

Comments to this Manuals

No comments

Sherwood RD-7503 Troubleshooting Guide Page 20

Comments to this Manuals

Related products and manuals for AV receivers Sherwood RD-7503