Sherwood RD-7503 Troubleshooting Guide download pdf (Page 47)

Continued

ENGLISH

When selecting the AUTO SURROUND

• Depending on how to select a surround mode, you can select the auto surround mode or the manual surround mode.

ON : The optimum surround mode will be automatically selected depending on the signal

(Auto surround mode) format being input.



OFF : You can select the desired of different surround modes selectable for the signal being

(Manual surround mode) input with using the MULTI CONTROL knob or the SURROUND MODE UP/DOWN ( >/< )

buttons. (For details, refer to "When selecting the manual surround mode with pressing the

SURROUND MODE button on the front panel" on page 25.)

Notes :

• Even when the auto surround mode is selected and the same type of digital signal format is being input, the optimum surround

mode may vary depending on whether the speaker type is set to "NO" or not.

• When the auto surround mode is selected, the surround modes other than the optimum surround mode cannot be selected.

When selecting the AV SYNC

• There may be a slight time delay between the video and audio signals in case that some video playback equipments may

process the video signals later than the audio signals due to signal processing procedure, etc.. Should this happen, you can

adjust the time delay of audio signals to synchronize the sound with the picture.

• The time delay can be adjusted within the range of 0 ~ 200 msec.

When selecting the DC TRIGGER

• To turn on the component connected to the DC TRIGGER OUT jack when this input source is selected, you should set the DC

TRIGGER to ON for this input source.

OFF : To turn off the DC trigger function.



ON: To turn it on.

• For details, refer to "CONNECTING DC TRIGGER OUT" on page 11.

When selecting the HD AUDIO

• When the source components that cannot support the HD audio signal format (such as Dolby Digital Plus, Dolby TrueHD,

DTS-HD High Resolution Audio, DTS-HD Master Audio, etc.) are connected to the HDMI IN of this receiver, some components

may not output any audio signals from its HDMI OUT.

In this case, you should set the HD AUDIO to OFF to play the audio signals other than the HD audio signals. (For details on

the audio signal format, refer to the operating instructions of the source component.)

ON : To play the audio signals (including the HD audio signals).



OFF : To play the audio signals other than the HD audio signals.

RD-7503(A) 2008.11.4 1:45 PM 페이지 47

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 68 69

No comments

Sherwood RD-7503 Troubleshooting Guide Page 47