Sherwood RD-7503 Troubleshooting Guide download pdf (Page 11)

9. CONNECTING DC TRIGGER OUT

• Connect a component to DC TRIGGER OUT jack

that allows DC 12V to turn on when a specific

input source is selected.

• For details, refer to the operating instructions of

the components to be connected.

• To link DC TRIGGER OUT with a specific input

source, refer to "When selecting the DC

TRIGGER" on page 47.

Notes :

• This output voltage (12V d.c., 100mA) is for (status) control only, it is not sufficient for drive capability.

• When making DC TRIGGER connection, you should use the stereo mini cord, not a mono mini cord.

ENGLISH

• ROOM 2 playback feature allows you to play a different program source in another room as well as one source in the main

room at the same time.

• For ROOM 2 playback, connect the ROOM 2 OUT jacks to the amplifier, TV, etc. installed in another room, or

connect the ROOM 2 speaker terminals to the speakers.

• Because this receiver cannot drive the surround back speakers and the ROOM 2 speakers simultaneously, you should

assign their power amplifier correctly depending on how to use them. (For details, refer to "When selecting the AMP

ASSIGN" on page 41.)

Notes :

• To minimize hum or noise, use high quality connection cords.

• You cannot use the digital audio signal for ROOM 2 playback.

8. CONNECTING ROOM 2 OUTS

RD-7503(A) 2008.11.4 1:45 PM 페이지 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 68 69

No comments

Sherwood RD-7503 Troubleshooting Guide Page 11