Sherwood RD-7503 Troubleshooting Guide download pdf (Page 21)

ENGLISH

LISTENING TO A PROGRAM SOURCE

Operations

Before operation

• Enter the standby mode.

• The STANDBY indicator lights up amber.

This means that the receiver is not

disconnected from the AC mains and a small

amount of current is retained to support the

operation readiness.

• To switch the power off, push the POWER

switch again.

Then the power is cut off and the

STANDBY indicator goes off.

• Then the SPEAKER indicator lights up

and the sound can be heard from the

speakers connected to the speaker

terminals.

• When using the headphones for private

listening, press the SPEAKER button

again to switch the speakers off.

• Each time the INPUT SELECTOR knob on the front

panel is rotated, the input source changes as follows:

TUNER  CD  TAPE  F.AUX  VIDEO 1 

(Frequency display)

 BT  VIDEO 3  V2/IPOD 

• Each time the BAND button (or the TUNER button on

the remote control) is pressed, the band changes as

follows:

 FM ST  FM MONO  AM  SIRIUS

�When selecting the EXTERNAL IN as desired,

• Depending on the power amplifier setting for the

surround back channels and the surround back speaker

setting, "EXT. IN" is displayed and 8(/7/6) separate

analog signals from the component connected to this

input pass through the volume circuits only and can be

heard from your speakers.

• Select the desired input source to cancel the external in

function.

• These analog signals can be heard only, not recorded.

Notes:

• Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 15 for details

about operation.

• Before operating this receiver, first set this unit as desired for optimum performance, doing the OSD menu setting

procedures. (For details, refer to "OSD Menu Settings" on page 39.)

• Each time the POWER ON/STANDBY button on the front

panel is pressed, the receiver is turned on to enter the

operating mode (the STANDBY indicator lights up blue)

or off to enter the standby mode(the STANDBY indicator

lights up amber).

• On the remote control, press the POWER ON button to

enter the operating mode or press the STANDBY button

to enter the standby mode.

• In the standby mode, if the INPUT SELECTOR knob is

rotated or the INPUT SELECTOR button is pressed, the

receiver is turned on automatically and the desired input

is selected.

1. In the standby mode, turn the power on.

3. Select the desired input source.

2. Switch the speakers on.

RD-7503(A) 2008.11.4 1:45 PM 페이지 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 68 69

Comments to this Manuals

No comments

Sherwood RD-7503 Troubleshooting Guide Page 21

Comments to this Manuals

Related products and manuals for AV receivers Sherwood RD-7503