Sherwood RD-5503 Operations Instructions download pdf (Page 19)

ENGLISH

Adjusting the current channel level

• Each time these buttons are pressed, the corresponding

channel is selected as follows:

→ REF 1, 2 (or CAL) ↔ FL ↔ C ↔ FR ←

→ <DD> ↔ SW ↔ SL ↔ SR ←

LFE level

< >: Only when the digital signals from Dolby Digital program

sources that include LFE signal are input, LFE level can be

displayed.

• Depending on the speaker settings ("N (None or No)") and

surround mode, etc., some channels cannot be selected.

• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit

your tastes.

• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory ("CAL"),

not into preset memory("REF 1", "REF 2").

• The LFE level can be adjusted within the range of -10~0

dB and other channel levels within the range of -15 ~ +15

dB.

• In general, we recommend the LFE level to be adjusted

to 0 dB. If the recommended levels seem too high, lower

the setting as necessary.

• Then the memory mode ("CAL", etc.) is displayed for

several seconds.

• When the memory mode or channel level disappears,

press this button again.

1. Press the CHANNEL LEVEL button.

2. Select the desired channel.

3. Adjust the level of the selected channel as desired.

4. Repeat the above steps 2 and 3 to adjust each

channel level.

RD-5405(A)_ENG100217_RD-5503(g) 2010-03-30 오전 10:53 페이지 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 118 119

No comments

Sherwood RD-5503 Operations Instructions Page 19