Sherwood RD-5503 Operations Instructions download pdf (Page 6)

ENGLISH

BD player, DVD player, tape deck, MD recorder, etc.

2. CONNECTING AUDIO/VIDEO COMPONENTS

3. CONNECTING DIGITAL INs

• The OPTICAL and the COAXIAL DIGITAL OUTs of the

components that are connected to CD and VIDEO 1 of this unit

can be connected to these DIGITAL INs.

• A digital input should be connected to the components such as a

CD player, DVD player, etc. capable of outputting Dolby Digital or

PCM format digital signals, etc.

• For details, refer to the operating instructions of the component

connected.

• When making the COAXIAL DIGITAL connection, be sure to use

a 75Ω COAXIAL cord, not a conventional AUDIO cord.

• All of the commercially available optical fiber cords cannot be used for the equipment. If there is an optical fiber cord which

cannot be connected to your equipment, consult your dealer or nearest service organization.

■Note : Be sure to make either a OPTICAL or a COAXIAL DIGITAL connection on each component. (You don’t need to do both.)

■Digital input default settings

• If you connect the DIGITAL INs to your components, it is easier to do so following the default settings.

• If your DIGITAL connections are different from default settings, you should assign the DIGITAL INs you used with the “When

selecting the DIGITAL IN” procedure on page 30.

• The default settings are as follows : OPTICAL : VIDEO 1, COAX : VIDEO 2

• The VIDEO 1/VIDEO 2 jacks may be connected to AUDIO jacks of video components such as BD player, DVD player, TV, etc..

• The TAPE IN/OUT jacks and the VIDEO 1 IN/OUT jacks can be connected to audio recording equipment such as a tape deck,

an MD recorder, etc..

■HDMI (High Definition Multimedia Interface) connection : (*)

• You can connect the source component (BD player, etc.) to the display component (TV, projector, etc.) through this receiver

with using a commercially available HDMI cord.

• The HDMI connection can carry uncompressed digital video signals and digital audio signals.

• This receiver can output digital video and digital audio signals from the HDMI MONIOTR OUT of this receiver without passing

through any circuits as they were input into the HDMI IN(, meaning the audio signals which are input into the HDMI IN cannot

be reproduced on this receiver).

• HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI licensing LLC.

■Notes :

• Depending on the connected component, unreliable signals transfer may happen.(For details, refer to the operating instruction

of your component)

• For stable signal transfer, we recommend using HDMI cords that are a maximum of 5 meters in length.

RD-5405(A)_ENG100217_RD-5503(g) 2010-03-30 오전 10:53 페이지 6

1 2 3 4 5 6 7 8 9 10 11 ... 118 119

No comments

Sherwood RD-5503 Operations Instructions Page 6